There are many problems that should be paid attention to in the application of stone removal machine

In the processing technology of wheat production and processing, the application of stone removing machine is inevitable. Should pay attention to a few questions in the application of the stone removal machine? The editor summarizes the following for everyone:

1. Independent wind network

The stone-removing machine mainly relies on the action of wind to classify the sand and wheat. The height of the wind and air pressure immediately determine the actual effect of stone removal. Therefore, it is necessary to equip an independent wind network, and select a moderate centrifugal fan according to the provisions of the user manual to ensure that it has a stable and sufficient exhaust volume and air pressure.

2. The screen is damaged seriously

After a long period of application, the sieve is worn away by the hand-woven wave pattern. The crushed stone is easy to deflect and flip on the surface of the sieve. It is difficult to jump and cannot be discharged uphill. It is easy to flow into the wheat inlet and outlet with the material. Will damage the stone removal effect. At this time, be sure to remove the screen.

3. The tightness of the connection between the machine and the equipment

There is a conductive soft connection on the inlet of the stone removal machine, the inlet and the air pipe. Once damaged, it will lead to instability of the exhaust volume and air pressure in the machine, and immediately jeopardize the actual effect of stone removal.

4. Whether the round hole screen is blocked

At this stage, most sieve stone removal machines use hand-woven stainless steel screens. After long-term use, residues such as steel nails and broken wires will be buried in the stainless steel screen, which will block the round hole screen and jeopardize the actual effect of stone removal. It is recommended to install a mineral processing equipment above the entrance of the stone removal machine.

5. The inclination of the screen surface should be moderate

If the inclination angle of the screen body is too large, it will be difficult for the gravel to go uphill, and the row of stones will become longer. Part of the crushed stone will flow into the wheat inlet and outlet along with the wheat stream, which will reduce the high efficiency of removing stones. On the contrary, the smaller the inclination angle of the screen body, the easier it is for the gravel to climb up the hillside. In addition, higher quality barley also climbed to the quarry. Therefore, the size of the inclination angle of the screen surface has a particularly important influence on the quality of the actual stone removal effect.

The above is the multiple problems in the application of stone removal machine that I want to share today. I hope to help everyone. See you next time!