Problems that should be paid attention to in the application of stone remover

In the processing technology of wheat production and processing, the application of stone remover is inevitable. What problems should be paid attention to in the application? The editor summarizes the following for everyone:

1. Independent wind network

The stone remover mainly relies on the action of wind to classify sand and wheat. The height of wind and air pressure in the stone remover will immediately impair the actual effect of the stone remover. Therefore, the stone remover must be equipped with an independent wind screen according to the user manual. Choose a moderate centrifugal fan to ensure that it has a stable and sufficient exhaust volume and air pressure.

2. The sieve powder is seriously damaged

After long-term use, the surface of the sieve can be polished by hand-woven wave patterns, and the gravel is easy to flow down and turn over on the surface of the sieve. It is difficult to jump and cannot be discharged. Make sure to remove the stone sieve powder at this time.

3. The sealing condition of the machine and equipment connection

Equipped with conductive soft connections on the feed inlet and air pipe. Once damaged, the exhaust and air pressure in the machine will be unstable, which will immediately impair the actual effect of the stone remover. Make sure to remove and replace the conductive soft connection immediately.

4. Whether the round hole screen is blocked

At this stage, most of the sieve powder of the stone remover is a hand-woven stainless steel screen. After long-term use, residues such as steel nails and broken fine iron wires will be buried in the stainless steel screen, thereby blocking the round hole screen and impairing the actual effect of stone removal. It is recommended to set up mineral processing equipment above the entrance of the stone removal machine.

5. The tilt angle of the screen surface should be moderate

If the inclination angle of the sieve body is too large, the gravel will be difficult to climb, and the rock discharge section will become longer. Some gravel will flow into the wheat inlet and outlet along with the wheat stream, which will reduce the high efficiency of stone removal. On the contrary, if the inclination angle of the sieve body is smaller, the gravel will help to rise, and the higher quality barley will also climb to the stone discharge opening. Therefore, the size of the inclination angle of the screen surface has a particularly important impact on the actual effect of stone removal.

The above is about the issues that should be paid attention to in the application of the stone removal machine. Thank you for your attention and support. If you want to know more, please pay attention to the official website of Yongming Machinery. See you next time!