Inner Mongolia hoist manufacturers Kopp bucket hoist and no broken hoist difference

Everyone has to understand the hoist, it should not be too understanding, then Xiaobian will share the difference between the characteristics of these two hoists.

Bucket elevator features:

1. The driving power is small, and it adopts inflow feeding, induction discharging, and large-capacity hopper intensive arrangement. There is almost no returning and picking when the material is lifted, so there is less reactive power.

2, a wide range of lifting, this type of hoist has less requirements on the type and characteristics of materials, not only can improve the general powdery, small granular materials, but also can improve the materials with greater abrasiveness. Good sealing and less environmental pollution.

3, the service life is long, the feeding of the hoist adopts the inflow type, no need to use the bucket to dig the material, and the extrusion and collision phenomenon rarely occur between the materials. The machine is designed to ensure that the material is less sprinkled during feeding and unloading, reducing mechanical wear.

4, the operation reliability is good, the advanced design principle and processing method ensure the reliability of the whole machine operation, and the trouble-free time exceeds 20,000 hours. The lifting height is high. The hoist runs smoothly and therefore achieves a high lift height.

5. The slow low-crushing bucket hoist is a fully enclosed square double-tube structure with stable operation, simple structure, safe and convenient operation, etc. It is suitable for vertical lifting of various granular materials.

The machine uses a lightweight high-strength engineering plastic bucket with rubber blocks between the bucket and the belt.

The thickness of the spacer is larger than the thickness of the granular material, which prevents the material from being crushed between the belt and the bucket.

At the same time, the bottom of the hoist is provided with a pull-type inserting board, which is convenient for material cleaning.

Features of no broken hoist:

1. No broken hoist has no upper and lower drive wheel drums, each transmission part does not collide with materials, squeezes, no rebound force when feeding, no returning when dumping

2. The noise during operation is 50% lower than that of the ordinary hoist.

3. Avoiding the link of the grain-sliding pipeline, it also eliminates the crushing caused by the impact of the material in the sliding of the slippery grain pipe.

4, can upgrade powder, granular, block and other materials, the new type of bucket elevator is to discharge the hopper through the unloading device in addition to unloading

5. When the running part is parallel or vertical, the hopper always feeds upwards (naturally depending on gravity), and the material is transported in the closed casing by the chain.

6. The hopper keeps the flexibility at -50 °C without brittleness, wear resistance, anti-aging and impact resistance.

7. The length of the upper horizontal section and the lower horizontal section can be customized and is 100 meters long.

Reprint statement:

The article is reproduced on the Internet for the purpose of transmitting more information and does not imply endorsement of its views or verification of the authenticity of its content. If the reprinted works infringe the author's right to authorize, or have other damages such