The key to the efficiency of cyclone dust collector

Cyclone dust collector is also called cyclone separator. The principle is that the dust-containing gas enters the tangential inlet of the cyclone separator at a certain speed, and is collected and separated under the action of rotating centrifugal separation. The inlet wind speed is the key to the efficiency of dust removal. What is the range of intake wind speed? Usually our design wind speed is kept at 18~23m/s, lower and higher than this value have great influence on dust removal efficiency.

1. When the wind speed is lower than 18 meters, when the wind speed does not reach a certain speed, the dust cannot rotate after entering, and centrifugal separation is not formed, and the dust removal efficiency is greatly reduced. When it is higher than 23 meters, the dust removal efficiency will also decrease, and too high wind speed will cause dust to overflow from the outlet of the cyclone dust collector, too late to share. At the same time, the resistance will be greatly increased. Therefore, the air inlet speed of the cyclone must be controlled within a certain range.

2. With high dust removal effect and low resistance, it has been widely used in mills.

3. The equipment has a better treatment effect on heavier dust, and the treatment of lighter contrast weight and fiber sawdust is lower.

The above is about the key to the efficiency of the cyclone dust collector. I hope that the above sharing can help everyone. Thank you for your attention and support. If you want to know more, please pay attention to the official website of Yongming Machinery. See you next time!