How to carry out daily maintenance of polishing machine

Polishing machines, also known as grinders, are commonly used for mechanical grinding, polishing and waxing. Its working principle is: the motor drives the sponge or wool polishing disc mounted on the polishing machine to rotate at high speed. Due to the combination of the polishing disc and the polishing agent and the friction with the surface to be polished, it can remove paint pollution, oxide layer and shallow marks. purpose. The rotating speed of the polishing disk is usually 1500-3000 r/min, most of them are continuously variable speed, which can be adjusted at any time during the construction process. The editor introduces the daily maintenance of the polishing machine:

1. The polishing machine needs to be maintained and maintained by a dedicated person, and it must be cleaned every day. The filtered and purified compressed air is used to purge the entire equipment to keep it clean and extend the life of the machine.

2. Each time the polishing machine is turned on, it will sit idle for a few minutes. Lubricate where friction and movement often occur

3. When the polishing machine is running and cleaned, the dust suction device should be activated.

4. The automatic oil injection system is installed on the polishing machine: the automatic oil injection pump will automatically inject lubricating oil into the equipment each time it is turned on. In addition, lubricating oil needs to be injected into the equipment again. The lubrication time can be set by yourself. For the setting method, refer to the instructions on the automatic fuel injection pump. "Every week, pay attention to check whether there is enough lubricating oil in the automatic fuel injection pump. If not, please add oil to the automatic fuel injection pump. The lubricating oil used is diluted lubricating oil. The amount of added oil can be increased to the height of the fuel rack 3/4.

5. Special attention should be paid to the automatic wax spraying device of the polishing machine:

a. Fill the polishing tank with polishing wax to 2/3 of the wax tank.

b. If the polishing machine is not used for a long time, the wax remaining in the wax spray gun should be automatically sprayed or cleaned with gas to prevent the wax remaining in the spray gun from solidifying and blocking the spray gun head.

The above is about the daily maintenance of the polishing machine. I hope it can help everyone in order to extend the life of the machine. Thank you for your attention and support. See you next time!