新闻动态
Your current location : Home page >> News >> Industry news

About the double selection machine maintenance method

2019-07-01
second

       

Introducing the Duplex Selecting Machine now, everyone must know what kind of machine is there. Does anyone know how to maintain this kind of machine for longer? Then the following small series will introduce you in detail, hope that small Editing the maintenance advice can help everyone.


      The compound seed selection machine has a wide adaptability. It can select seeds such as wheat, rice, corn, sorghum, beans, rape, pasture and green manure by changing the sieve and adjusting the air volume.


      The machine has high requirements for use and maintenance, and a slight oversight will affect the quality of the selection. The main points of use and maintenance of the machine are as follows:


       1. The selection machine is working indoors. The parking place of the machine should be flat and solid. The parking position should be convenient for dust removal.


       2. If the conditions are limited, it must be operated outdoors. It should be placed in a shelter and placed in a downwind to reduce the impact of wind on the selected effect. Wind barriers should be considered when wind speeds greater than level 3.


       3. When changing the variety, be sure to remove the residual particles in the machine and keep the machine running for 5-10min. At the same time, adjust the handle switch several times before and after to eliminate the front, middle and back chambers and the deposition chamber. After confirming that no seeds and impurities have flowed out of several storage chambers, the machine can be stopped. The seeds and impurities on the upper sieve surface are first cleaned to the discharge tank, and then the upper sieve surface is removed and cleaned. screen.


       4. Before each operation, check whether the fastening screws of each part are loose, whether the rotation is flexible, whether there is abnormal sound, and whether the tension of the transmission tape is appropriate.


       5. Fill the lubrication point.


       6. Cleaning and inspection should be carried out after each operation, and the fault should be eliminated in time.


复式精选机.png


Reprint statement:


The article is reproduced on the Internet for the purpose of transmitting more information and does not imply endorsement of its views or verification of the authenticity of its content. If the reprinted works infringe the author's right to authorize, or have other damages such


Label

Recently browses: