Correct installation steps of pulse dust collector

The pulse dust collector is relatively small in size, which can greatly save the installation area during use and installation, and improve the efficiency of use. The key is to make the dust removal effect high. It is widely used in various metallurgical industries as air purification treatment or to realize the recovery of useful materials. After all, it adopts the split-room stop-wind pulse soot blowing technology, which can achieve the purpose of cleaning the dust at one time, so it has a good performance in soot blowing and vacuuming. In the spraying process, prolonging the cleaning time can reduce the energy loss during the cleaning process, so the energy saving advantage is more prominent.

Of course, the pulse dust collector adopts a good partitioned vacuum technology. At this time, the cloth bag can be repaired or replaced without stopping the air volume of the fan. Therefore, the advantages that it can bring in terms of efficiency are obvious. The dust removal effect is obviously improved. Of course, in order to be able to get it, we need to have a more reasonable treatment at this time, otherwise it will cause energy loss. In view of this, we know from the above that the advantages of dust collectors are very obvious, not only energy saving, but also the effect of dust removal and dust removal has been significantly improved.

The 5 correct installation steps of the pulse dust collector:

1. When lifting the pulse dust collector, care should be taken to prevent deformation. When the equipment leaves the factory, the key parts are welded with lifting lugs, please use the lifting lugs for lifting.

2. After the pulse dust collector box, bag room, air inlet and outlet, ash hopper, etc. are installed, all connections should be airtight. If welding and sealing are required, and those that are welded firmly and connected by fasteners, gaskets should be added for sealing. Tighten all fasteners. Local air leakage, use silica gel or epoxy resin to stop air leakage and rain. The sealing quality of the pulse dust collector is an important factor affecting its normal operation and life. The dust collector requires an air leakage rate of less than 3%.

3. When the gas path is assembled, the main gas pipe has been separately manufactured in the factory. As long as it is assembled on site, the control air pipe (connected to the lift cylinder) is installed on the spot, such as the material, the sleeve, etc., all the pipelines need to be cleaned. If there is debris, all joints should be filled with sealing material, and no air leakage should be allowed after pressure test.

4. The installation of the bag cage and filter bag is a careful and thoughtful work in all installations, so it is necessary to install afterwards. When installing, the filter bag must not collide with hard objects or scratch, even small scratches will shorten the service life of the filter bag. The method of installing the filter bag is to first put the dust-removing cloth bag from the flower plate hole of the box body into the bag room, and then pinch the spring ring on the upper part of the bag mouth into a concave shape, insert it into the flower hole plate of the box body, and then restore the spring ring . Press it tightly on the circumference of the flower hole, and then gently insert the bag cage from the mouth of the bag until the upper cover of the bag cage really presses on the flower plate hole of the box. In order to prevent the filter bag from being stepped on, it is necessary to install the dust collector, filter bag, dust bag cage, and flower hole plate every time the filter bag is installed.

5. After the bag cage on the pulse bag filter of the coal mill wind box is installed, the pressure plate should be installed to make the ground wire, the bag cage and the flower plate on the filter bag close contact. The door on the coal mill wind box pulse bag filter has been adjusted before leaving the factory, and it does not need to be adjusted during installation.

The above is the correct installation steps of the pulse dust collector. Thank you for your attention and support. If you want to know more, please pay attention to the official website of Yongming Machinery. This site will share more good articles for you. See you in the next issue...